String Efficiency and Methods to improve string efficiency

String Efficiency:

    Now let us discuss about string efficiency and the methods used to improve string efficiency.What is string efficiency ? String efficiency is the ratio of voltage across the whole string to the product of number of discs and the voltage across the disc nearest to the conductor.

              The voltage applied across the string of suspension insulators is not uniformly distributed across various units or discs.The disc nearest to the conductor has much higher potential than the other discs.This unequal potential distribution is undesirable and is usually expressed in terms of string efficiency.

                  

               String efficiency is an important consideration since it decides the potential distribution along the string.The greater the string efficiency, the more uniform is the voltage distribution.Thus 100% string efficiency is an ideal case for which the voltage across each disc will be exactly the same.Although it is impossible to achieve 100% string efficiency, yet efforts should be made to improve it as close to this value as possible.

Must Read:

• Potential distribution over a string of suspension insulators

Methods to improve string efficiency:

            It has been explained in the post potential distribution in a string of suspension insulators is not uniform.The maximum voltage appears across the insulator nearest to the line conductor and decreases progressively as the cross arm is approached.If the insulation of the highest stressed insulator (i.e. nearest to conductor) breaks down or flash over takes place, the breakdown of other units will take place in succession.This necessitates to equalize the potential across the various units of the string i.e. to improve the string efficiency.  

The various methods to improve the string efficiency are :

(i) By using longer cross-arms : The value of string efficiency depends upon the value of K i.e., ratio of shunt capacitance to mutual capacitance.The lesser the value of K, the greater is the string efficiency and more uniform is the voltage distribution.The value of K can be decreased by reducing the shunt capacitance.In order to reduce shunt capacitance, the distance of conductor from tower must be increased i.e., longer cross-arms should be used. However, limitations of cost and strength of tower do not allow the use of very long cross-arms.In practice, K = 0·1 is the limit that can be achieved by this method.

                                   

(ii) By grading the insulators : In this method, insulators of different dimensions are so chosen that each has a different capacitance.The insulators are capacitance graded i.e. they are assembled in the string in such a way that  the top unit has the minimum capacitance, increasing progressively as the bottom unit (i.e., nearest to conductor) is reached.Since voltage is inversely proportional to capacitance, this method tends to equalize the potential distribution across the units in the string.This method has the disadvantage that a large number of different-sized insulators are required. However, good results can be obtained by using standard insulators for most of the string and larger units for that near to the line conductor.

(iii) By using a guard ring : The potential across each unit in a string can be equalized by using a guard ring which is a metal ring electrically connected to the conductor and surrounding the bottom insulator as shown in the Figure below.The guard ring introduces capacitance between metal fittings and the line conductor.The guard ring is contoured in such a way that shunt capacitance currents i1, i2 etc. are equal to metal fitting line capacitance currents i′1, i′2 etc.The result is that same charging current I flows through each unit of string.Consequently, there will be uniform potential distribution across the units.